微信注册 一步即可
您需要 登录 才可以下载或查看，没有账号？立即注册  
x
SAE J292-1995 SNOWMOBILE AND SNOWMOBILE CUTTER LAMPS,REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT
Foreword-This Reaffirmed Document has been changed only to reflect the new SAE Technical Standards Board Format.
This SAE Recommended Practice is intended as a guide toward standard practice, but may be subject to frequent change to keep pace with experience and technical advances. Hence, its use where flexibility of revision is impractical, is not recommended.
1. Scope-This SAE Recommended Practice describes requirements for lamps, reflective devices, and associated equipment for signaling to enable safe operation in darkness and other conditions of reduced visibility.
2. References
2.1 Applicable Publications-The following publications form a part of the specification to the extent specified herein. Unless otherwise indicated the lastest revision of SAE publications shall apply.
2.1.1 SAE PUBLICATIONS-Available from SAE,400 Commonwealth Drive, Warrendale, PA 15096-0001.
SAE J68-Tests for Snowmobile Switching Devices and Components
SAE J277-Maintenance of Design Voltage-Snowmobile Electrical Systems
SAE J278-Snowmobile Stop Lamp
SAE J279-Snowmobile Tail Lamp(Rear Position Lamp)
SAE J280-Snowmobile Headlamps
SAE J564-Headlamp Beam Switching
SAE J592-Clearance, Side Marker, and Identification Lamps
SAE J594-Reflex Reflectors
3. Application-This document applies to snowmobiles and snowmobile cutters.1
加载中请耐心等待。双击可全屏预览。发现文档有侵权/水印/二维码/链接等请举报。
| 
xwuw13 