微信注册 一步即可
您需要 登录 才可以下载或查看，没有账号？立即注册  
x
SAE J308-1996 (R)AXLE AND MANUAL TRANSMISSION LUBRICANTS
Foreword--This Document has not changed other than to put it into the new SAE Technical Standards Board Format.
In 1943, the U.S. Army Ordnance Department (currently U.S. Army Belvoir Research, Development and Engineering Center) began qualifying gear lubricants against U.S. Army Specification 2-105. This specification has gone through several revisions and is now identified as MlL-L-2105D. The American Petroleum Institute recognizes gear lubricants meeting this latter specification as API Service GL-5(API GL-5).
In 1977, the U.S. Army terminated direct sponsorship of the qualification process and contracted with SAE to a)perform the reviewing activity, and(b) make recommendations relative to the acceptance of candidate products under the military gear lubricant specification. In accordance with its contract with SAE, the U.S. Army retains sole responsibility for approving and qualifying products to its specification.
Following termination of the U.S. Army sponsorship, the SAE Board of Directors established a Lubricants ReviewInstitute(LRI), which in turn has established an LRI Gear Lubricant Review Committee. This committee developed procedures for submitting candidate lubricants for review as well as procedures for reviewing such lubricants. The LRI activities are reviewed by SAE Legal Counsel to ensure compliance with applicable federal and state laws.The LRI Gear Lubricant Review Procedures can be obtained from SAE headquarters in Warrendale, PA.
1. Scope-This SAE Information Report was prepared by the SAE Fuels and Lubricants Technical Committee for two purposesa) to assist the users of automotive equipment in the selection of axlel and manual transmission lubricants for field use, and (b) to promote a uniform practice for use by marketers of lubricants and by equipment builders in identifying and recommending these lubricants by a service designation.
2. References
2.1 Applicable Publications-The following publications form a part of the specification to the extent specified herein. Unless otherwise indicated the lastest revision of SAE publications shall apply.
2.1.1 SAE PUBLICATIONS-Available from SAE,400 Commonwealth Drive, Warrendale, PA 15096-0001.
SAE J306-Axle and Manual Transmission Lubricant Viscosity Classification
LRI Gear Lubricant Review Procedures
加载中请耐心等待。双击可全屏预览。发现文档有侵权/水印/二维码/链接等请举报。
| 
wc99588 