SAE J278-1995 SNOWMOBILE STOP LAMP

Foreword--This Document has not changed other than to put it into the new SAE Technical Standards Board Format.
This SAE Recommended Practice is intended as a guide toward standard practice, but may be subject to frequent change to keep pace with experience and technical advances. Hence, its use where flexibility of revision is impractical is not recommended.

1. Scope-This SAE Recommended Practice provides test methods and requirements for the stop lamp on snowmobiles.

2. References
2.1 Applicable Publications-The following publications form a part of this specification to the extent specified herein. The latest issue of SAE publications shall apply.
2.1.1 SAE PUBLICATIONS-Available from SAE,400 Commonwealth Drive, Warrendale, PA 15096-0001.
SAEJ567-Lamp Bulb Retention System
SAEJ575-Test Methods and Equipment for Lighting Devices and Components, for use on Vehicles Less than 2032 mm in Overall Width
SAEJ576-Plastic Materials for Use in Optical Parts Such as Lenses and Reflectors of Motor Vehicle Lighting Devices
SAEJ578-Color Specifications

3. Definitions
3.1 Stop Lamp-Lamp giving a steady light to the rear of a vehicle to indicate the intent of the operator of a vehicle to stop or diminish speed.
3.2 Multiple-Compartment Lamp-A device which gives its indication by two or more separately lighted areas which are joined by one or more common parts such as a housing or lens.
3.3 Multiple Lamp Arrangement-An array of two or more separated lamps on each side of the snowmobile which operate together to give a signal.

加载中请耐心等待。双击可全屏预览。发现文档有侵权/水印/二维码/链接等请举报。

感恩楼主的分享！

谢谢了拉

谢谢你，温暖了四级~下载了