SAE J279-1995 SNOWMOBILE TAIL LAMP(REAR POSITION LAMP)

Foreword-This Document has not changed other than to put it into the new SAE Technical Standards Board Format.
This SAE Recommended Practice is intended as a guide toward standard practice, but may be subject to frequent change to keep pace with experience and technical advances. Hence, its use where flexibility of revision is impractical is not recommended.

1. Scope-This SAE Recommended Practice provides test methods and requirements for tail lamps for snowmobiles.

2. References
2.1 Applicable Publications-The following publications form a part of this specification to the extent specified herein. The latest issue of SAE publications shall apply.
2.1.1 SAE PUBLICATIONS-Available from SAE,400 Commonwealth Drive, Warrendale, PA 15096-0001.
SAE J567-Lamp Bulb Retention System
SAE J575-Test Methods and Equipment for Lighting Devices and Components, for use on Vehicles Less than 2032 mm in Overall Width
SAE J576-Plastic Materials for Use in Optical Parts Such as Lenses and Reflectors of Motor Vehicle Lighting Devices
SAE J578-Color Specifications

3. Definitions
3.1 Tail Lamp-Lamp used to designate the rear of a snowmobile by a steady-burning, low-intensity light.
3.2 Multiple-Compartment Lamp-A device which gives its indication by two or more separately lighted areas which are joined by one or more common parts such as a housing or lens.
3.3 Multiple Lamp Arrangement-An array of two or more separated lamps on each side of the snowmobile which operate together to give a signal.

加载中请耐心等待。双击可全屏预览。发现文档有侵权/水印/二维码/链接等请举报。

太多积分了

不错滴